MOLD insert

These freshly finished inserts are what we recently made for our Polish customers.In fact, we... read more

What is two shot injection molding?

Two shot injection Molding, also called over-molding multi- component or 2K Injection molding, employs separate injection points... read more

Things you need to know about Overmolding

Overmolding injection process is used in many areas to create finished plastic parts and improve... read more

Tips on Injection Molding Technolog of POM Plastic parts

  What is POM? POM,,also calles as acetal, Polyoxymethylen is a kind of thermoplastic plastic particles with... read more

Everything you need to know about Insert mold  

What is injection molding process？ INSERT MOLDING is a type of injection molding. It is the... read more

What is Mold Flash and How to fix it?

Flash is a one of the top 10 common plastic problems that most plastic injection molders usually... read more

An quick tip to improve injection molding process within 5 minutes

Well, this is an important technique that could help injection molders to improve molding process... read more

How to Control Color Difference In Plastic 

The color of plastic injection molded parts might be a huge issue if not controlled... read more

Case Analysis of Defects in Car Door Panel

There are normally four Interior door pannels in a car, including Front, Rear, Left and... read more

Best way to deal with ejector pin marks?

For injection molders, it should be very common to see white ejector mark or pin... read more

Everything that you need to know about plastic hor runner mold

The hot runner is heated to ensure that the plastics of the runners and gates... read more

The cause of shrinkage of injection molded parts and how to solve them

I believe that many mold manufacturers have encountered a plastic defect-shrinkage on injection molded parts.... read more